Skip to main content

Thin slab and minimum embedment for adhesive anchor

Posted by Colin Wu32 minutes ago
Thin slab and minimum embedment for adhesive anchor

I have a 3.15" (80mm) slab and plan to use 3/8" HIT HY-200 anchors. The specified minimum embedment depth is 2 3/8" while the minimum slab thickness for this embedment is 3 5/8" per table 38. Is it ok for me to specify 2" or 2 1/8" embedment depth? Will it affect the installation procedure (such as setting torque, pretension, etc)? I only need minimal shear capacity (700 lbs each), not tension capacity. 2" meets the 4da minimum embedment requirement of ACI 318 though.

adhesive,anchor,embedment

No replies yet

Be the first to reply to this question!