Posted by David Sedikalmost 2 years ago
Designing anchors with HIT-RE 500 V3 using core drilled holes with large annular gap
The following link shows a special technical guide for HIT-RE 500 V3 with large holes. Can this be used in the profisengineering calculations?
Technical-information-ASSET-DOC-LOC-7502228.pdf (hilti.com)
1 Reply
Posted by Ashley Couronalmost 2 years ago
Hi David,
The information in Hilti's technical bulletin for HIT-RE 500 V3 with a large annular gap cannot be used with PROFIS Engineering. PROFIS Engineering is limited to the technical information that is within ESR-3814 for HIT-RE 500 V3.
Regards,
Ashley