Can't change stud length in Hilti Profis - software and anchor design, Profis engineering software

Posted by Emily Farquharsonalmost 4 years ago

Can't change stud length in Hilti Profis

Usually i can adjust the length of studs / anchor bolts in Hilti Profis, but profis is not allowing me to do this right now. Has anyone had a similar issue? How did you get around this?

software and anchor design,Profis engineering software

3 Replies

Posted by Emily almost 4 years ago

Hilti Verified

Hi Emily,

Thank you for brining this issue to our attention. We are currently investigating the issue.

Regards,
Emily

Posted by LUKASZEWICZ CANDICEalmost 4 years ago

I was just logging on here to search a solution for the exact same issue. Following!

2 comments on this reply

Posted by MELISSA BLANEYalmost 4 years ago

I tried that and while the embedment depth changed, the program won't run.

Posted by Emily Farquharsonalmost 4 years ago

so i found a work around... switch to a HAS rod, then increase embedment depth, then switch back to the nelson studs

Posted by vijaykanth pulumatialmost 4 years ago

HI Emily, Was this ever reolved?