Engineering Center

I have a license for Profis enginering suite. Is there a separate Hilit program that is dedicated to post installed rebar? Or is all that functionality in Profis?

I am looking to design into Brick in hilti profis however I only see CMU block. I used to use profis for brick applications. What am I doing wrong?

Followed the holllowcore plank guide here for anchors in tension in hollowcore precast: https://www.bing.com/ck/a?!&&p=cd3849d38aab3323749a0ef3185ca2bbaf727b1e07f2859fc9de3a8eaccc1b2aJmltdHM9MTc3MTQ1OTIwMA&ptn=3&ver=2&hsh=4&fclid=3f4e06e2-099e-68e8-14b6-10a00845692c&psq=hilti+precast+plank&u=a1aHR0cHM6Ly9maWxlcy1hc2suaGlsdGku...

What is the recommended firestopping system to use for pneumatic tubing thru an existing concrete wall that is pre-approved by HCAI/OSHPD?

My design features hollow leveling feet. The feet go through the baseplate, with a pair of nuts above and below the baseplate, to allow for leveling the baseplate relative to the ground. The bottom of the levelling foot features a pad that rests on the ground. Each levelling foot is hollow, to allow an anchoring rod to through...

going though clean room 1 walls

There are some precast wall panels that I would like to anchor to. They are 8 thick, 3 of concrete on either side and 2 of insulation in the center. The anchors will be outdoors. I would like to get about 600 lbs. of tension capacity per anchor. What are my options for a post-installed anchor?

I have contractor that is requesting to use PAFs i.l.o. screws to connect perforated steel decking. Are PAFs allowed to be used in steel decking that is perforated? Specifically looking at the X-ENP 19 metal deck fasteners where we are connecting perforated metal decking to HSS framing members.

I am unable to access the webinar quiz from the link sent. Is there a way to access the quiz from the website?

Is there a minimum distance specified in the listed firestop system that must be maintained beyond the point of firestopping for through-penetrations when transitioning between dissimilar materials (for example, from a copper pipe to low-density polyethylene (LDPE))?