Engineering Center

The concrete slab has been poured. No embedded channels were installed. a seismic rated "Flush" attachment is required since the circuit breakers roll in and out of the switchgear. are there any products with after set drilling and chemical that will produce a surface that can be welded to?

How close to the edge of the slab can hilti bolts be installed

There had been no website feed back following submitting my quiz

I have a situation where 3/4” diameter Kwik Bolt TZ anchors were installed into a CMU (for a particular connection). The spacing of the anchors is 5”. Table 45 and 46 show that the minimum required spacing between the anchors is 6” to be able to use the load/capacity tables. Since the installed anchor spacing of 5” does not me...

The existing floor consist of 25mm granolithic flooring + 150mm R.C.C floor (with #3@150mm reinforcement) + 100mm P.C.C 1:4:8 (approx. 800 to 1200 psi compressive strength). The effective bolt length is of 172mm and this will be fixed in 25mm granolithic flooring and 150mm R.C.C floor. Can you confirm the effectiveness of bolt...

We found undercut 's minimum required concrete thickness is inconsistent between product specification and ICC-ESR report. For M12 HDA-PR, specification shows minimum concrete thickness 7.5in while ICC-ESR show 7.9in. Which one is correct? Please refer to attachment.

I intend to use your products on board US Navy ships and need to know if they are qualified or qualifiable. See pictures for uses on board European naval combatants.

I have some old Kwik Bolt anchors. some of them have a "D" stamped on the end, and some have a "G" stamped on the end. The "D" anchors appear to be 3/8" and the "G" anchors are much bigger. What do the markings mean?

Can I use the intumescent FP on B-Decking

I am looking for a 1 hr rated solution for a steel to CMU safeing condition