Engineering Center

How do you save a project? Every time I print a report and go to home, all the values are zeroud out and I have to input all the values again

I've seen a few posts regarding firestopping the top of a wall from one side but they pertain to shaft walls. Do you have a system to firestop a 1 hour rated metal stud wall from one side? We are trying to assure firestopping at the top of wall but one side is not feasibly accessible due to existing steel framing. Top of wa...

HOW TO INVOKE HAC IN PROFIS

When switching between results for the number of sidelaps vs sidelap spacing, I'm getting different values. All other inputs remain the same. Example1, See zone 2L on attached. Sidelap spacing = 36", but # of sidelaps = 2, seems like this should be 1 sidelap. See zone 3L spacing = 36" but number of sidelaps = 1. This makes se...

When installing the MSI for a Hilti plug in that works with Click2CAD, the installation fails. We've already given full admin access to that folder and to the appdata temp folder, including (for the time being) an asterisk wildcard in the temp folder. Where else would this software attempt to install that could be blocked?

I am inquiring as to what the hole tolerances are for has E anchors. The spec calls for 9/16 but is 5/8 within tolerance?

Designing for HUS-EZ. The program message says that the "anchor is to close to the profile, required 0.861" " I do not understand. Pls explain. thanks.

Is there a way to add a second attachment to the plate analysis?

What's the recommended Hilti epoxy anchor system for anchoring up into the underside of terra cotta arches (floor structure), and where do I find performance (pull-out) data?

Is there a difference between "Create a Company Project" VS "New Project" tabs on my Hilti Profis profile? I have been noticing a lot of my internal company projects created out of another office (I can tell from the project codes) and I believe that creating a "Company Project" leads to this. I have the following questions...