Engineering Center

Why are the HDA Undercut Anchors in PROFIS? I cannot find them. Have they been intentionally omitted or am I doing something wrong?

Hello Hilti , Everytime I use Hilti Profis I'm asked about multiple accounts. Can delete account number 0023893577 and update the address to 151 W Vista Ridge Mall Dr. Lewisville, TX 75067

Please confirm that for HLC sleeve anchors in the face of grout-filled block there is no minimum embedment into the grout itself. Table 4 of the product technical guide requires a minimum embedment of 1-1/4" for 3/8" diameter anchors. Since the face shell for 8" CMU is 1-1/4", the minimum anchor embedment as measured from th...

Can we confirm that the installation torque value for a carbon steel 5/8" KB-TZ2 is 40 ft-lb ? Looking at the technical document, the installation torque for the 1/2" has a greater value than the 5/8". Seems unintuitive.

What is the Wet Mil and Dry Mil this product should be installed at?

Can base plate and member properties for aluminum be accommodated in PROFIS?

HI, The breakout capacity of an HDI-P TZ anchor differs significantly depending on which tension type of loading is selected. In the attached file, if differs from 107% overstress (17.2.3.4.3(a)) to 356% using the other four options, including not seismically loaded. This is using ACI318-14. We noticed that when 17.2.3.4.3(d)...

Do you have any anchors that have ESR reports suitable for anchoring 2x4 sill plates to a 2000 psi concrete slab on grade?

Unitrut opening is 7/8”, and we are trying to confirm if we can use 3/8” or ½” bolts.   Please confirm the size of KWIK BOLT TZ2 that can be used for Unistrut mounting, considering the socket size required for installation

find out if used nailgun isn't stolen