Engineering Center

I am using Hilti PROFIS to design cast-in-place anchors. I have shear loads and overturning moments. If I only input shear loads in the model, the anchor bolts will pass the design. If I input shear loads and overturning moments together, the anchor bolts will fail by shear. Looks to me the overturning moments affect the shear...

I am unable to create a report when performing a diaphragm analysis in Profis. There are no error messages, and all zones are green. I have included a screenshot of the program. When I hover over the create report button, the mouse symbol changes to a Do Not Enter symbol.

Hello, I am looking for a detail for a fire-resistive joint system where a metal stud rated wall terminates at the underside of wood decking and/or if installed perpendicular to the structure, will also need to go around existing glulams.

I am a bit confused on the calculation of Ca1 for concrete breakout for this particular anchor layout that I am looking at. One would think that Ca1 would be 12''. Ha is 14'' and Ca2 is 40''. So provision 17.7.2.1.2 does not apply. But it seems like that are calculating Ca1 as ha/1.5. Hence, the reason why I am getting 9.333 a...

We are installing a (14) 4 long Bronze tapered hexagon lane rope anchors into an existing gunite wall. Diameter is 1 with staggered hexagons that steps down along the length at 1 intervals. I am planning on using a 1 1/8 carbide hammer drill along with a rebar cutter if needed. It is located in the back wall of a pool gutter w...

We would like to use the HI/BPF 120-11 detail or similar with a 4 slab instead of a 6 slab as outlined in the assembly description. The condition we have only requires a 1-hour rated assembly. Is there a design # or UL listing for a 1-hour rated floor to ceiling curtain wall firestop assembly with 4 slab?

Does Hilti offer the slide deck for participants after?

Morning - I need to install (16) 1-1/2 diameter by 20 long anchor rods in an existing concrete slab, these anchor rods require a 12 embedment. We are utilizing HY 200-R V3 epoxy, and will be using a diamond core to make the holes due to rod diameter and existing rebar in the slab. I was wondering if 1) utilizing a core drill t...

How do I take the quiz for a webinar i just attended? They quickly gave an overview at the end of the presentation but there is no information online as far as i can tell...

What is the metric undercut anchor with 0.625 inch in diameter of stainless steel?