Engineering Center

under the plate / washer tab it will only allow a 6" diameter. How can I input a larger size

how can i become a qualified trainer for my company.?

Given a 6" Concrete housekeeping Pad over a 6" Concrete Slab, can we assume 12" effective thickness for anchor design

The anchor I want to use says it is not standard for my thickness of foundation and to check with hilti

Is there a way to manually adjust the tensile strength of the anchor bolts on Hilti's anchor bolt design program?

I want to know that why do we seal vertical openings (cables, pipes, duct) from one side only while we seal walls from both sides.

While I was trying to design a concrete foundation, I realized that the forces in the Y direction were being applied in the X direction according to Hilti. I have attached 3 PDF's. In PDF 1, It shows the reactions applied to the anchors. The only thing that I found strange is when I looked at pg.3 of the document it states tha...

We're designing the post-install connection. We have a limitation of a maximum of 8.375" from one edge of the wall and the wall thickness is 8". The main failure is Concrete Edge Failure in direction-x (4.3). In option 1, you can see the parallel,V is 2.00. However, the file I attaches has a larger edge distance but the parall...

The firewall at a building separation is (2) parallel rated shaft walls, 2" apart. Where I have a rated door through this firewall, does the 2" gap (annular space btwn walls) at the head & jambs need to be fire stopped?

Hi, I tried to select the anchor position for the metal deck type anchor to "Top", but the cursor shows a "X" and wouldn't let me select it. Is there a condition where the anchor position at the top is not allowed? Why is software not allowing me to select the top position?