Engineering Center

If not, can they be added?

Does Hilti have a screw or other mechanical fastener to brick for anchoring of furring channels, etc.

I am working on a project under construction where there is a fire-rated roll-up door face mounted to a 1-hour fire-rated gypsum wall assembly. The State Fire Marshal deputy wants to see an Engineering Judgement for the fire-rated wall where the opening of the wall meets the fire roll-up door hood. Because this condition is ne...

Can Kwik Bolt TZ anchors be installed at an angle other than 90° into concrete? If so, what is the recommended angle range, and what is the impact on the capacity of the anchors? This other post references an older answer to a similar question, but the link is broken: Kwik bolt at an angle - Reduced capacity, Angle of installa...

When selecting the Embed plate family in Profis, the only available Type is Embed plate D1.1 GR. B. AWS D1.1 does not refer to a grade B. Is this GR. B meant to refer to the type B for stud anchors for defining material property requirements (table 9.1)?

Does HILTI have any information or documentation on the shrinkage rates on individual products? Most specifically, I'm looking for the most common three that we use, FS1, CP606 and CFS-SP WB Fire Spray.

Hello, When I attempt to register for your free webinars, I get the following error message: This has been occurring for several days, preventing me from registering. I have an account and I am logged in during these failed attempts to register. Please let me know if there is a different way I should be registering.

I received an email from you about this webinar, but I can't register it. It says not session

Need help registering, I'm getting the error shown in attached when I click Register.

Each time I have tried to register for the Quality Control of Firestop Installation, an error message appears. Please review and relay how to properly register. Thank you,