Engineering Center

The concrete foundation for my base plate is a circular drilled shaft. The only geometry I see available is for square or rectangular shapes. Is there was way to specify a circular shape?

I want to use 1/4" KWIK HUS-EZ (KH-EZ) but only 1/2 5/8 & 3/4 are available in program. Why is this?

On a project where the contractor has drilled holes that are too deep for the anchor. If the hole is filled with epoxy (HY200 in this case), what is the consequence of not inserting the anchor to full extent of the hole?

Can you create a custom anchor layout while using the Anchoring to Masonry Design tool?

I wondered if adhesive materials like Excelsior WB-600 or Excelsior C-630 can be applied on CP- 605 FIRESTOP SEALANT at the bottom of the wall. Is there a chemical compatibility issue?

As I understood it, HY 200 V3 works best for certain load-bearing applications and ones that require certain approvals, while HY 100 is for non-load-bearing applications such as handrails. What are other example applications of each? What criteria must be considered when switching the latter to the former?

How long does concrete have to cure before the installation of rebar pins using HY-200 adhesive?

Was rebar removed from anchoring to concrete? I can not find it as a selection anymore.

cantilevered base plate with 3 anchors in a triangular pattern, can the software calculate capacity when a shear force, moment and axial load is applied somewhere on the square plate

I am looking to set some J shape #4 rebar 8 inches deep in a cement pillar. I am going to use epoxy to do so. How big should my hole be when im using (1/2 inch) #4 rebar