Engineering Center

When logging into my PROFIS Engineering account, company projects from other users are not displaying in my home page. When I login on the Ask Hilti page though, I can confirm that I am associated with my company's license/subscription.

Can Hollow Brick Wall Thickness be Changed?

What is the difference between CFS-S SIL GG & FS-ONE MAX?

The coefficient Kc for cast-in place and post-installed anchors in CSA A23.3 Appendix D is different from those proposed by ACI 318 Section 17. This is due to the unit differences of the two standards. However, in the calculations that PROFIS reports, it seems that the same values of Kc (the ACI ones) are used in the calculati...

I upgraded the Profis to premium but could not find how the baseplate and stiffener design works. Would you help me in this regard?

Hello, I would like to know if kwik bolt 3 is approved in Florida?

When I run an analysis on six threaded rods in two columns and three rows at 16" on center, Profis output indicates a spacing reduction factor of 0.579. When I look at ICC-ES ESR-4143, Tables 3A and 3B I get an interpolated reduction factor of 0.76. Are we supposed to use a spacing reduction factor for vertical and horizonta...

Is there a design manual for Hilti Profis that explains the various parameters in detail and references them to specific code provisions? I cannot find one online.

Hello i would like to ask about the approximate movement capability for CP 620 firestop foam

We need to face nail LP Smart Siding prefinished starter board to a concrete foundation wall. Can you recommend a fastening system that has a small fastener head.