Engineering Center

Posted by thierry EFFAabout 4 years ago

BASE PLATE THICKNESS

Just to know why a base plate thickness is not calculated since we got the premium subscription (see the report ) . Did I miss to select something ?

baseplate design and chor design,Profis engineering software

Posted by John Reedabout 4 years ago

Printing a Report in Another Language

I am currently working in the program with the language set to German. However, when I print the report, it prints in English. How I do get the report to appear / print in German?

print out material,Language

Posted by awbabout 4 years ago

Turn Off Alternative Fastening in Reports

When I print a report from Profis Engineering, I am getting some pages with "Alternative Fasteners" that Profis says also work. How can I turn this unwanted feature off?

Profis,Alternative Fasteners

Posted by Aaron C Hellamabout 4 years ago

In the Decking 201 Webinar it was stated spot welds cannot be made in (4) plies of deck. I understood that the parameter is based on total thickness of plies(0.15") and not number plies. Can you refer me to the standard that limits the number of plies?

Deck Fastening webinar

Posted by Omar AbuKarabout 4 years ago

PROFIS DF diaphragm software

There are two definitions of lengths in the software. The first when you specify the (L) length and Width (B) of the building. While the other with the load definition. What is the purpose of the length with the load definition?

PROFIS DF diaphragm,Length definition

Posted by Frank Bennardoabout 4 years ago

Anchors into Grout filled CMU in seismic design category D

I used profis to design anchors into masonry and I couldn't find any anchor that is approved for seismic application. which anchor into grout filled CMU should I use for seismic regions projects

Seismc,chemcial anchors,grout filled CMU

Posted by Jeremy Ingramabout 4 years ago

Hilti Pins fastening deck to steel beams with intumescent paint on them

I have a customer who wants to shoot hilti pins for attaching his deck however; the beams are coated with a intumescent paint approximately 110 mils. Is this achievable using X-ENP-19 L15 ?

X-ENP-19,Fasteners in intumescent

Posted by Robert Kaseeabout 4 years ago

Install Recommendations for Adhesive Anchors in Green Concrete

How soon can adhesive anchors (HIT-HY 200-R V3 w/HAS Rods) be installed and torqued in green concrete that is greater than 3 days and less than 28 days in age?

Green Concrete,adhesive anchors

Posted by Sam Okayabout 4 years ago

Large Diameter post installed anchor rods

I have a tall stack the contractor wants to use post installed anchor rods. The stack manufacturer specifies 1 1/2" anchor. Does Halti have 1 1/2" post installed anchor of any kind?

large diameter,post installed

Posted by Timothy Eric Nehlsenabout 4 years ago

Firestop PVC in cold form steel build 5 stories

What UL recommended for penetration of Schedule 40 PVC drain waste vent through rated walls/floors. What would you recommend where the pipes are vertical through the bulkhead wall space but with a rating above and below in the floors and ceilings.

Fire stop PVC,UL

Showing 2251-2260 of 2889 Results