Engineering Center

When I export a design from RISA Connection to Hilti Profis, why are all torsion loads (Mz) on a group of anchors set to zero?

Using the 200 adhesive in concrete what size drill bit is used for 3/8 rod

What is equivalent to ASTM 193 B-7 standard anchor bolt in Hilti Anchors portfolio

Does Hilti still provide training cards for installation of epoxy anchors and fire stopping systems? The outside sales agents had given this type of training in the past. There is nothing on the Hilti Academy for these but it does say coming soon?

Is there a hilti detail for a 2 hour wall (U419) and a steel column similar to the clip attached to this note?

We need to install firestopping from below to close pipe and duct penetrations through the ceiling slab of this unit, and have no access to the top surface of the slab. The penetration does not occur within a wall cavity. Construction Floor assembly is 8" thick concrete floor slab. We have two conditions. 1) At the Floor slab,...

Limit of 20d is set in Profis for design of post-fixed anchors, is there a minimum requirement for minimum embedment in-built in Profis? Which standards is this based on?

What could be the solution if the labor in the site didn't stick to the minimum spacing in a rebar case and already make some holes close to each other?

Can you please provide me with a drill size chart for your various size HAS rods

Can you do baseplate analysis with Quik HUS EZ bolts?